Young Curly Brunette Girl Shows Off In Front Of Curtains

Coated fabrics consist of a standard uncoated fabric with an opaque rubber backing applied to the rear of the fabric to provide improved light absorption. To create a coated fabric a liquefied rubber polymer is applied in a single coat to an uncoated fabric and subsequently fused dry by means of a heated roller, in much the same way that a laser printer applies toner to a sheet of paper before fusing it dry. A fabric that has been through the coating process once is considered a 1 pass coated fabric, anecdotally referred to as dim-out or blackout because of the fabric's ability to absorb approximately 50-70% of a direct light source. To improve the light absorption of a fabric it is possible to re-coat a fabric up to a maximum of 3 pass coated, which is considered sufficient to block out 100% of a direct light source, hence such fabrics are referred to as blockout coated.
Maximum light absorption and heat insulation in a curtain is created through a lined curtain, which typically consists of an uncoated fabric at the front to provide the look and feel of the curtain, with a separate coated fabric attached at the rear to provide the insulative qualities. The coated fabric is typically referred to as a lining, which simply refers to a coated fabric that does not have any particular color or pattern.
Curtains may be held back with tie-backs or may be closed and opened with sticks called draw-pulls or curtain rods which are attached either to the runner or to the first hook. On some curtain rails/poles, there is pulley system for opening and closing called corded curtain tracks. The knobs at the end of these cords are called cord pulls or acorns.
A curtain hook stopper is a device used to stop the curtain from falling of the end of the curtain rail.