Young Dark Blonde Girl Reveals Her Black Top At The Door With A Mobile Phone And Headphones

The design is not mechanically stable; a slight imbalance makes the armature stick to one pole of the magnet. A fairly stiff restoring force is required to hold the armature in the 'balance' position. Although this reduces its efficiency, this design can still produce more sound from less power than any other. Popularized in the 1920s as Baldwin Mica Diaphragm radio headphones, balanced armature transducers were refined during World War II for use in military 'sound-powered' telephones. Some of these achieved astonishing electro-acoustic conversion efficiencies in the range 20% to 40% for narrow bandwidth voice signals.
Today they are typically used only in canalphones and hearing aids due to their diminutive size and low impedance. They generally are limited at the extremes of the hearing spectrum (e.g. below 20 Hz and above 16 kHz) and require a seal more than other types of drivers to deliver their full potential. Higher end models may employ multiple armature drivers, dividing the frequency ranges between them using a passive crossover network. A few combine an armature driver with a small moving-coil driver for increased bass output.
• Other transducer technologies
Transducer technologies employed much less commonly for headphones include the Heil Air Motion Transformer (AMT); Piezoelectric film; Ribbon planar magnetic; Magnetostriction and Plasma-ionisation. The first Heil AMT headphone was marketed by ESS Laboratories and was essentially an ESS AMT tweeter from one of the company's speakers being driven at full range. Since the turn of the century, only Precide of Switzerland have manufactured an AMT headphone. Piezoelectric film headphones were first developed by Pioneer, their two models both used a flat sheet of film which limited the maximum volume of air that could be moved. Currently TakeT produce a piezoelectric film headphone which is shaped not unlike an AMT transducer but which like the driver Precide uses for their headphones, has a variation in the size of transducer folds over the diaphragm. It additionally incorporates a two way design by its inclusion of a dedicated tweeter/supertweeter panel. The folded shape of a diaphragm allows a transducer with a larger surface area to fit within smaller space constraints. This increases the total volume of air that can be moved on each excursion of the transducer given that radiating area.