Young Brunette Girl Waking Up In The Bed

Bed rails and frames are often attached to the bed post using knock-down fittings. A knock-down fitting enables the bed to be easily dismantled for removal. Primary knock-down fittings for bed rails are as follows:
• Pin-and-hook fastener. A mortise or slot is cut vertically in the bedpost. Pins are inserted horizontally in the bed post so that the pins perpendicularly intersect the mortise. For example, if one looked in the mortise, one might see part of one horizontal pin at the bottom of the mortise and a part of a second pin toward the top of the mortise. Hooks are installed at the end of the rail. Usually these hooks are part of a plate that is attached to the rail. The hooks then are inserted into the bed post mortise and hook over the pins.
• Plate-and-hook fastener. Instead of pins inserted horizontally into the bedpost, an eye plate (post plate) is installed on the bedpost. The hooks are installed on the rail, either as surface mount or recessed. Depending on the hardware, the bedpost may require a mortise in order to allow the hooks to fasten to the plate. This is also referred to as a keyhole fastener, especially if the connector is more of a "plug" than a "hook".
• Bed bolts ("through-bolts") are a different means of a knock-down connection. A hole is typically drilled through the bedpost. The bolt head is inset and covered with a plug. In the rail, a dowel nut or other type of nut receives the bolt. The springs are made from metal, which are swirled for maximum comfort